How to Perform a 3 Point Bend Test on a Universal Testing Machine

Home / Testing Guides / How to Perform a 3 Point Bend Test on a Universal Testing Machine

Bend testing (also flex or flexural testing) is commonly performed to measure the flexural strength and modulus of all types of materials and products. This test is performed on a universal testing machine (tensile testing machine or tensile tester) with a 3 point or 4 point bend fixture.

Image of bend fixture on eXpert 2600
3-Point Bend Test Setup on a Dual Column eXpert 2600

The key analysis when performing bend testing are:

  1. Flexural Modulus – This measures the slope of a stress / strain curve and is an indication of a material’s stiffness
  2. Flexural Strength – This measures the maximum force that a material with withstand before it breaks or yields. Yield is where you have pushed a material past its recoverable deformation and it will no longer go back to the shape it once was.
  3. Yield Point – The yield point is the point where the material essentially “gives up” or the point where if you were to continue to bend the product, the force will not continue to increase and will then start to decrease or break.

Test Report from ADMET’s MTESTQuattro Testing Software:

Test report for a bend test generated by MTESTQuattro
3 Point Bend Flexural Test Report

By: Andrew DeWolfe | Published on: July 23, 2010 | Last Updated: January 6, 2026

Just Ask!

Have a question about bend testing?

We’re ready to help!

Contact Us Today
spiral arrow graphic

Testing Guides

  • Medical Adhesive Testing Basics

    Medical adhesives are specialized substances used to bond medical devices, tissues, or other components together. They must comply with strict biocompatibility requirements and are vital in surgeries, wound care, and medical equipment manufacturing.

  • Deflection & How To Use A Deflectometer

    Deflection, in materials science, is the amount a material deflects under compressive load. It is a displacement measurement with units expressed in millimeters or inches. This post goes over frequently asked questions around deflection measurements and equipment used to measure them.

  • Peel Strength Testing

    Peel strength is calculated by averaging the load to peel the specimen and dividing it by unit width of the bond line.

  • Tensile Testing FAQs

    Tensile testing FAQs including How does the loading rate affect tensile properties? How does grip-specimen engagement affect tensile properties? What is the best way to measure small strains? are answered.