There are many test methods used to determine the strength of an adhesive including peel, shear, cleavage, and tension tests.  Peel tests are common for tapes, labels, coatings, and other bonded materials.  There are three main types of peel tests including 90 degree peel test, 180 degree peel test, and a T-Peel test.  The Loop Tack test is similar in concept but is better classified as a tension test.

Why would you perform the T-Peel test instead of the 90 or 180 degree test?  Well, the 90 and 180 degree tests are commonly used where a flexible material with an adhesive or other bonding method is adhered to a more rigid substrate.  You would use the 90 over the 180 degree peel test if your flexible substrate can’t be bent cleanly back to 180 degrees.  The T-Peel is used when both materials are either similar or both flexible.

The T-peel test requires that both of the bonded substrates are flexible.  This means that they need to be able to be bent up to a 90 degree angle without breaking.  Both substrates do not need to be the same material.

This is a quick summary of the ASTM D1876 specification to decide if this test is right for you, and to point out what equipment you need to perform the test.

Equipment Required:

  1. Universal Testing MachineASTM D1876 T-Peel Test Setup on a Universal Testing Machine
    1. 1 kN capacity single column UTM is usually enough for this test.
    2. Servo controlled to keep a constant rate of speed.
  2. Tensile Grips (2)
    1. Each peel substrate needs to be held securely
  3. Software to calculate peak load and average load between extension points

Test Procedure

  1. Load each end of the sample into opposing tensile grips
  2. Separate grips at a constant rate of speed (see spec) throughout the length of the specimen (about 9 inches)
  3. Report peak load and average load per unit width of bond

ASTM D1876 T Peel Test Report


Contact us today!

Have a question about ASTM D1876 testing?

We're ready to help!
Contact us today!